The upper cover to cover. The bottom face up in the tooling, the 5 ST3*12 fastening screw to screw the cover for electric screwdriver. The dust cup mounted to the machine. The fan blades are flat down to under ultrasonic tooling mold. Wind leaf convex super, 3 holes at the wind leaves 3 fixed columns on the wind leaf. My hands start ultrasonic tool, the blade cover is fixed to the wind leaf. The fan component fixed blade cover. The dust cup sleeve to the ultrasound tooling die. The trademark cover as shown in the direction of the dust cup trademark cover groove. My hands start ultrasonic tool, the trademark cover to the dust cup. Dust cup assembly.
The dust cup figure mounted ultrasonic tooling die fixed. The dust cup mouth is arranged to dust groove cup mouth. The film covers the dust cup, the hands start ultrasonic tool, the dust cup mouth is fixed to the dust cup. Ultrasonic good dust cup mouth dust cup assembly. The dust cup as icon sets the direction to the fixture mould. The front wheel of the big end of the flat end into the front wheel, rotate the wheel to determine wheel to rotate smoothly, then the front wheel flat alignment dust cup shaft hole wear to the dust cup. The hands press tooling button, the axle pressure to the dust cup. Pressure wheel dust cup assembly. The dustproof plug to an air inlet dust cup. The filter screen seat and the inner component self out. 3.6V.
With a clean cloth to the dust cup of oil dirt, clean. The nameplate label affixed to the bottom of the label groove. Take color tape is folded 20mm, then the switch will be bubble color tape switch button on the back of the machine, as shown in the diagram of protective bubble edge to switch from the visual is greater than 5mm, with the tape around a circle of fixed. Round the elevator tie to elevator inside. Handle the elevator tie line to the upper. The whole into a plastic bag (Note: the elevator on the bottom). The conical bubble as shown by color tape is fixed on the paper tray. Will the dust cup upwards, according to shape into a paper holder (elevator discharge.
The box marks affixed to the box at the bottom of the box, the box according to the folding into graphic shape, according to the sequence shown folded at the bottom. The Russian brochure, manual, warranty card such as graphics and fold. The manual assembly as shown in figure into the next, then the box from top to bottom to the whole. The manual, warranty card, Russian pamphlets as shown stacked together, the sticker box (as shown), then the box from top to bottom are installed. The upper cover is covered on the paper box, button to Caconne. The box on the electronic scale weighing, no leakage or is installed accessories. The outer box according to the folding into shape. The box with tape to the bottom.
The box on the electronic scale weighing, no leakage or is installed accessories. The outer box according to the folding into shape. The outer box at the bottom of the tape to seal a way. Will be installed to the outer box 6 box machine, box direction to be consistent. The upper cover is covered outside the box, to the word the way sealed with tape. The outer box neatly placed on pallets.